no you only need to connect 3.3 volts, ground and data to gpio 24, of course this may not be used by another function.
make sure you use the correct gpio pin configuration.
1 post is enough to get an answer
Volumio version 3.324
I set the GPIO pin to gpio24
I have some IR sensor
ground
middle pin Volt
s pin signal out.
So i connect all three jumper wire and connected them to 3.3v pin/ ground pin/ gpio24 pi that is mart in the snapshot
[image]
[ir]
[GPIO-Pi4]
So, today, a booted up the player and grabbed the JustBoom remote which i have selected on Volumio and i tried but nothing happed when hitting the buttons on the remote
I have about the same problem. first, i went over here to the GPIO configurations
[ir]
Ihave a JustBoom IR Remote and set the IR Remote configuration to the JustBoom IR Remote and scrolled on down to GPIO configuration and set the GPIO to 24.
[GPIO-Pi4]
and connected the Jumper wires to 3.3v/ GPIO24/ Ground.
I connected the other end of the wires to to the IR sensor Modular
[irsensor]
Ground/ middle VCC or power/ s Single out.
So i have the wires to their right pin
ground to ground
…
I have the Volumio going and it works, but still problems with the ol’ Ir sensor.
I have a good many of these here from amazon
(Universal IR Infrared Sensor Receiver Module)
First i set the GPIO plugin configuration after selecting JustBoom IR Remote that i have and went down to the GPIO configuration and set the gpio to pin 24 on the Pi 4
[ir]
Later after i did that, i took one of the IR Infrared Sensor Receiver Module https://www.amazon.com/gp/product/B087ZRD3LH/ref=ppx_od_dt_b_asin_titl…
