outputs xrandr can open display 0
additional info on display 
volumio@victorumio:~$ sudo get-edid | parse-edid
This is read-edid version 3.0.2. Prepare for some fun.
Attempting to use i2c interface
Problem requesting slave address: Device or resource busy
No EDID on bus 1
No EDID on bus 2
No EDID on bus 5
2 potential busses found: 3 4
Will scan through until the first EDID is found.
Pass a bus number as an option to this program to go only for that one.
256-byte EDID successfully retrieved from i2c bus 3
Looks like i2c was successful. Have a good day.
Checksum Correct
Section “Monitor”
Identifier “Waveshare-07”
ModelName “Waveshare-07”
VendorName “WSH”
# Monitor Manufactured week 20 of 2023
# EDID version 1.3
# Digital Display
# Display Physical Size not given. Normal for projectors.
Gamma 2.20
Option “DPMS” “false”
Horizsync 1-255
VertRefresh 20-120
# Maximum pixel clock is 290MHz
#Extension block found. Parsing...
#WARNING: I may have missed a mode (CEA mode 70)
#DOUBLE WARNING: It’s your first mode, too, so this may actually be important.
#WARNING: I may have missed a mode (CEA mode 70)
#DOUBLE WARNING: It’s your first mode, too, so this may actually be important.
#WARNING: I may have missed a mode (CEA mode 70)
#DOUBLE WARNING: It’s your first mode, too, so this may actually be important.
#WARNING: I may have missed a mode (CEA mode 70)
#DOUBLE WARNING: It’s your first mode, too, so this may actually be important.
#WARNING: I may have missed a mode (CEA mode 70)
#DOUBLE WARNING: It’s your first mode, too, so this may actually be important.
#WARNING: I may have missed a mode (CEA mode 70)
#DOUBLE WARNING: It’s your first mode, too, so this may actually be important.
#WARNING: I may have missed a mode (CEA mode 70)
#DOUBLE WARNING: It’s your first mode, too, so this may actually be important.
Modeline “Mode 2” -hsync -vsync
Modeline “Mode 0” -hsync -vsync
Modeline “Mode 1” -hsync -vsync
Modeline “Mode 3” -hsync -vsync
Modeline “Mode 4” -hsync -vsync
Modeline “Mode 5” -hsync -vsync
Option “PreferredMode” “Mode 2”
EndSection