the correct thing would be to indicate “at the moment not available”. Wait for this plugging then. Honestly in my particular case and once installed volumio3 and at the moment I do not see the reason to pay more than double the previous one in a virtuous Mode.
I did it…it works
1 Like
Thank you
1 Like
Can’t comment at that one. Please contact support at volumio dot com for a refund.
I’ll keep waiting for the dsp and equalization modes. Thanks
Her you can follow the progress:
1 Like
Can we reproduce the ISO DSD with Volumio 3?
back a first success in the configuration of volumio 3 in a Rasbsperry pi3 at the third start I get the error ALSA not found the device volumio and nothing I can hear.
Could you help me??
The same thing happened to me and I have solved it by removing the SD card and installing the new version fresh.
1 Like
Hello, yesterday I was able to solve it from the settings by resetting the factory settings … but I don’t know if it will happen again
Hello to all and congrats on the new version.
I run my installation on a PineA64 board. I enabled Test mode thus I upgraded it to ver. 2.916.
And it doesn’t update to 3.
What should I do to upgrade it to v.3?
1 Like
There is no Volumio 3 yet for any of the boards in the community portings category.
Some work has been completed, but there is still a lot to be done.
First beta versions were out (Odroids), but they are only for the brave ones.
Hope to do them all in Q1 2022, no preciser ETA I’m afraid.
No, Volumio 3 has been released for the three officially supported platforms, Raspberry PI, Asus Tinkerboard and X86.
This is following the normal process, community portings always come afterwards.
Based on the PI and Tinkerboard experience, the community portings will be done in a second stage.
Not by the Volumio Team but the community member which created support for the board.
Work on Odroids has started, the others will follow.
Ofc I can only speak for the ones I have done.
1 Like
Thank you very much for clarifying it
Will Volumio 3 resolve the sampling rate synchronization issue that leads to the beginning of tracks getting cut off on playback via digital outputs? As discussed here - @volumio any news on this? Hoping to buy new hardware and Volumio 3 subscription if this issue has been resolved!
OK, so after the dust has settled, both my Volumio V3 systems are up and running better than ever and talking to each other via multiroom.
A major upgrade where thousands of users have to re-install all their settings is never going to be easy, especially as so many may not have done a fresh install for a couple of years. I want to say thank you to the amazing folks at @volumio - V3 is worth all the trouble and really feels like a huge step forward. Plus a huge shout out to the wonderful plugin developers who have put so much effort into getting their much-loved plugins to work again.
5 Likes
Adding issues in the middle of a general topic may not be the best way to draw attention to a problem.
I added it to the open issue list nevertheless.
Thanks @gkkpch, I wasn’t sure if this was really an open issue for V3, and also where to best post it! Glad it’s being tracked, looking forward to hearing if the issue is resolved or not!
1 Like