What a difference!
measured from 4 different positions in my room and let HouseCurve do the math, uploaded the text file in Fusion DSP, made some minor changes to map my listening position and voila! Turning the new setting on and off from the playback interface > you have to create a new preset and give that one a new name.
Congrats and thanks to the developers, it is worth every penny!
Used HouseCurve on my iPhone
And have a 2.1 setup with a tube amplifier, Wharfedale Denton’s 85th and a SVS SB1000 Pro
I got arounds the clipping of Airplay doing the sweeps with Bluetooth into Volumio. With Sine it works after 2-3 tries. With Pink noise right away. Is Bluetooths sq good enough for measurement?
If you’re playing music via Bluetooth, then I think it would be fine. If you intend to use other sources, I might not rely on it for measurements… bluetooth sq is iffy. I’m surprised pink noise works but the sweep doesn’t. Your system might still be clipping, pink noise could be hiding it.
The FusionDSP plugin has a toolkit that includes the HouseCurve sweep file (scroll to the bottom of the FusionDSP settings, add toolkit, select sweep to play). You could try that for measurements (put HouseCurve in external sweep mode).
Hi Greg, I have a Hegel Amp which never clips using Airplay. I remember reading somewhere that Hegel applies a workaround to control volume internally, whereas Airplay protocol apparently dictates volume to be applied at the sending device. Could this be a hint for you?
For ios I can recommend Owlfiles. It integrates well with ios Files. I had no issues with file transfers to Volumio. Hope it helps
thank you
Worked like a charm. I think I created L+R conv. filter in HouseCurve. FusionDSP however asks separate filters for L and R. So I just loaded same filter file for L and R. Does ot matter?
Is there an alternative to rephase for Mac users? Is there any point if I have a perfectly symmetrical room and am free to place my “triangle” where I please?
Thank you
When new audio files are installed by Tools, the database is updated and a new ‘FusionDsp’ album appears in your library. The update should only take a few seconds.
Yes, you can select the same file.If the wav file contains 2 channels, the first one is L and the second is R. But I never check it. Can you share your file to test?
Thanks!
It sounds much better than without. Of course I can always redo HouseCurve procedures again separating L and R. Laziness and lack of a mic stand are my only obstacles:) I’m not sure if the mic position being slightly different b/w L and R measurements is a problem. Also bass modes are cumulative. no?