Hello, I am new to and excited about volumio. I have limited experience with *nix, single board computers and digital audio. I have installed volumio 2 version 0.979 on a raspberry pi 3 with a HiFiBerry+ clone DAC. The hardware, including wireless networking, the webserver and DAC appear to be working.
When I attempt to access the volumio at volumio:3000 I can see the web interface but it is masked buy a dark box and a “spinner.” (see attachment) I can reload the page, use a different browser or machine, restart mpd, the result is the same.
/var/log/volumio.log doesn’t appear to have any pertinent information in it but I’m happy to share whatever might be helpful. I must admit I’m at a bit of a loss. Thanks in advance for any help or ideas.
If I edit local-config.json to reflect the rpi’s IP address, I can get into the interface. This workaround seems less than optimal as the device is getting its address via DHCP…
I’m connecting wirelessly, encrypted network, hidden SSID. When I set it up initially, I didn’t know about the initial hotspot and configuration of wireless, etc. through the web interface. I connected a monitor and keyboard and edited /etc/network/interfaces by hand to get the wireless working. I’ve made any subsequent changes over ssh.
Ok that’s a hint. So probably, what’s happening here is:
your manual configuration prevents the NAT rules from being loaded properly (they get loaded when a network interface is brought up).
You can solve by adding :
A followup to my manually mucking about with system settings and breaking stuff:
I did a “factory reset” from the “system settings” page. I was able to easily connect to the hotspot, change network settings and everything worked exactly as it should. Thanks again michelangelo, et. al.
