I’m trying to install Volumio v3 onto a Raspberry pi 4 that I plan to then connect and use with a Waveshare 7.9 do.
I’m coming across a few problems at install. I instal and image onto a Samsung micro SD card using Raspberry’s imager. It seems to load fine but the WebUI it gives me is 174.0.0.1 rather than a 192, I then can’t seem to connect via SSH to load plugins etc to get it to the Waveshare.
So far I have tried:
loading the image from Mac and a PC
use different SD cards
Usebdifdeent USB ports to download the image to
I keep getting to the same point of not having the right IP address. Does anyone know what I might be doing wrong!
Thanks for your help everyone. I downloaded the image from Volumio’s site, and used th Raspberry imager to store it onto an SD card. Loading it up I now get the attached image. It asks to give reboot password for maintenance and I don’t have one. control-d just brings me back to the same issues. Does anyone know what I do next?
When Volumio is installed afresh, it is configured to run as access point (AP) with SSID starting with Volumio. Simply connect to said Volumio AP and reconfigure WiFi to match your need, i.e. connect to your hub, router, etc as any other device, by selecting your network AP and corresponding credentials, like you would do with any other device using WiFi.
Connect your Pi 5 using CAT5e (as minimum, CAT6 or higher is preferred) network cable to your router, hub, etc and you should see your Volumio IP address served from your hub’s, router’s, etc DHCP process. You can configure WiFi to match your needs.