I’m not sure if this is placed correctly in this thread.
As written in this post, one of my rotary encoders has stopped to work properly.
I’m using “rotary encoder II” module which works perfectly until including 4.005.
Today I have double checked if I’m not facing hardware issues:
Using a differend SD card with 4.005 or even the stable release the encoder hardware works properly.
Now in the beta release rotation on the first encoder needs tons of movement to produce a single event.
Rotation signals (A/B) are connected to GPIO 22 and 27 in my installation.
Functionality-wise the rotation of this encoder is connected to volume up/down - which works if connected to the second decoder. Also switching the GPIOs to the consecutive other encoder switches the error, so from my view signals from the GPIO 22/27 are not read properly.
Any hint/advise would be great.
As said initially I’m not sure if this is a module or a system issue (I would tend to the latter …) but I give it a try here in the module section.
If ever possible I would try to avoid using other GPIOs because HW is build up complicated and this would cause huge effort to re-assemble…
Thanks a lot.
Regards,
Ralf