Duplicating my post in the Volumio 4.x thread re Fusion errors and no playback when convolution filters are enabled.
Fresh install of 4.011. I use it headless with SATA via USB. Only running Fusion DSP and Sys backup/restore plugins.
I had one false start where the system did not come back online after completing first config via built-in wifi. Didn’t seem like the system actually registered the connection to my local wifi, but it allowed me to step thru to finish. (No logs, sorry).
Wiped the SD, tried again, worked 2nd time.
With Fusion installed but disabled, and with it enabled as 3-band EQ, playback was normal.
I use convolution filters and with those enabled, playback broke with a bunch of Fusion errors showing in the live log.
This log starts with a reboot, then enable 3 band, then convo filters. 2
I wasn’t sure if this should go in @balbuze’s Fusion thread or here. I’m not too savvy with code but I can run a few more tests if it’s helpful.
OS info
Version of Volumio: 4.011
Hostname: volumio4beta
Kernel: 6.12.27-v7l+
Governor: performance
Uptime: 0 days, 2 Hrs, 4 Minutes, 10 Seconds
Network info
Interface: wlan0
IP Address: x.x.x.x
MAC Address: xxxxxxxxxxx
Type: wireless
Speed: nullMb/s
Audio info
Hw audio configured: HiFiBerry DAC2 HD
Mixer type: Hardware
Number of channels: 2
Supported sample rate: 44100 48000 88200 96000 176400 192000
Board info
Manufacturer: Raspberry Pi Foundation
Model: Raspberry Pi 4 Model B Rev 1.4 Raspberry Pi
Version: d03114
Firmware Version: Available only for RPI
CPU info
Brand: BCM2711
Speed: 1.5 GHz
Family: Cortex-A72
Model: 3
Number of cores: 4
Physical cores: 4
Average load: 36%
Temperature: 59°C
Memory info
Memory: 8031992 Ko
Free: 6703096 Ko
Used: 1328896 Ko
Software info
Mpd version: Music Player Daemon 0.24.3 (0.24.3)
Storage info
INTERNAL storage - Size: 52978Mo
Used: 272Mo
Available for storage: 49880Mo (94%)